Skip NavigationView Sitemap

AKON-Products AKON Werkzeuge GmbH

Workpiece holder sets for dies and taps

Workpiece holder sets for dies and taps: Make cutting threads easy! With our AKON holder set you can easily cut male and female threads of different sizes on standard turning machines. Acquiring high-precision while saving time are among the advantages of using our proven products.

Holder sets for drills

Holder sets for drills (trick with the click): Turn your drill into a thread cutter in a jiffy. Simply insert the mandrel into the drill spindle, push back the blue aluminium sleeve and fit the holder with groove onto the parallel pin. The aluminium sleeve slips back into place and is held by a ball.These AKON holders can be used on all common pillar drills with left-right rotation.The mandrel MT2 and four die holders with cutting range M3 to M14 are supplied in a handy plastic toolbox.

Workpiece holders for taps

Workpiece holders for taps: The AKON-holder for taps centers the tap exactly in the provided drill-hole. A finely aligned positioning results in a perfectly straight thread. No stripping of thread and no distortions occur. Cut your threads in an uncomplicated way, fast and high in quality.

Workpiece holders for male

Workpiece holders for dies: With the AKON-holder for dies you can cut male threads easily and precisely. Just put the die into the workpiece holder and the work can begin.

Mandrels

Mandrels with adjustable torque coupling: The mandrels with adjustable torque coupling are especially appropriated to cut a thread on drill-holes with a limited depth.The required torque of your thread which is to be cut can be regulated easily.The adjusting sleeve is regulated on the thread to be cut with the result that it is possible to cut as far as the depth of the hole. It is not possible for the tap to break off, as the torque coupling would first loosen.

Slide hammer set

Threading tool holders using Hand/cordless drills: These AKON holders enable cutting/recutting of external threads using hand/cordless drills. The holder can be directly attached to the drill and therefore immediately ready for use. The blue guide attachments facilitate cutting perfectly straight new threads

Short workpiece holders with 1/2 inch

Holders for recutting damaged threads with a ratchet: These workpiece holders for dies DIN 223 were developed specially for recutting damaged threads with a ratchet. (In all types of vehicles for example, on construction sites, for use by plumbers, heating installers etc.). The ½ inch square workpiece receiver is designed for all standard socket spanner sets.

Self-opening die heads

Self-opening die heads: RUBOMETRIC die heads are suitable for cutting right and left hand threads, any form and length of threads and materials, for cutting close to the shoulder.The die heads can be used on turning machines, turret lathes, single and multi-spindle automatic lathes, threading machines, drilling machines, or on other machines that are suitable for cutting threads.

Slide hammer set

Slide hammer set: For the easy extraction of cylinder and taper pins, pulley wheels, wedge bars, etc. Wide range of applications with the most common bit sizes. The extension bar allows for the slide hammer bar to be lengthened as needed, therefore allowing for increased force transmission.A high degree of tensile strength is achieved due to sculpted, fine connection threads.Complete set with a compact design that is both sturdy and easy to handle.

+49(0)7031 - 73 10 23
Back to top